Facing Trouble while Setting up Mywifiext?

Wifi range extenders are becoming a part of daily lives as it is used to extend your network coverage area. Netgear extenders cover the space where your existing router fails to reach. In this article we will tell you the ways by which you can set up your new netgear extender using mywifiext portal. We will also tell you some tips and tricks by which you can experience better performance. 

Further in this article you will get the complete information on new netgear extender setup so, stick with the article till end. 

Before you start the mywifiext installation procedure

Before you continue the installation procedure, there are few things you need to consider. Here are some points you need to follow: 

• Keep your extender at the same location as your existing router. Once the installation procedure is complete, you can relocate your extender to your desired place. 
• Ensure that your existing router is spreading proper internet across the area.
• Make sure to keep your extender and router away from the concrete walls, room corners as these things are like hurdles for the internet connections. 
• Keep your netgear extender away from electronic appliances that interfere with the signals physically.
• Electrical appliances like baby monitors, refrigerators, microwave ovens, televisions etc. 
• Make sure that the ethernet cable you are going to use is not damaged. 
• Keep your firmware and browser up to date. 

Once you take care of all the things mentioned earlier, it is time to get straight to the installation procedure.     

New netgear extender setup complete procedure - mywifiext.net

• Plug your new netgear extender in the near electricity plug. 
• If the LED indicators are not blinking, try to push the on/off button. 
• Now wait for the led indicators to get stable. 
• Once done, look for the WPS button on your netgear extender. 
• Now press and hold the WPS button for almost 15 seconds and then release it. 
• Once the WPS LED indicators start blinking, do the same procedure with your existing router. 
• Look for the WPS button on your router.
• Now press and hold the WPS button for 15 seconds straight and then release it.
• Now take any of your wifi enabled pc or laptop and choose an updated web browser to continue the installation procedure. 
• Launch the web browser and click on the address bar on it.
• Type www.mywifiext.net and hit the enter button. 
• If you don’t get automatically redirected to the new netgear extender web setup portal, try using the IP address that is 192.168.1.250 and hit the search button. 
• Now enter the admin credentials that is your username and password in the given blocks. 
• Your username must be “admin” and password should be “password” or no password at all.
• Hit the login button.
• Now look for the available network in your area.
• Find your new netgear extender network and click on it to get connected. 
• Now follow the on-screen instructions carefully and save the settings in the end by clicking on the finish button. 
• Once the setup is complete, change the location of your netgear extender. 
• Keep your netgear range extender in the place where it can get proper internet networks from your existing router. 
• Once placed, take any of your smart devices and try to connect it with your new network. 
• If connected, congratulations. You are all set to surf the internet. 
• Enjoy buffer free streaming. 

Ending 

If you are still facing the same problem, let us know by communication below the article and we will reach you with the proper assistance ASAP. 

Is your problem resolved?